sheet width 2500 mm︱plate thickness 6,00 mm︱distance between columns mm︱upper beam stroke 600 mm︱adjustment lower beam max. 100 mm︱bending beam adjustment max. 100 mm︱connected load OW 5,5 / BW 7,5 kW︱voltage 50 Hz, 400 V︱total power requirement kW︱weight of the machine ca. 7,00 t︱dimensions of the machine ca. m︱

---

• Bending angle adjustment via potentiometer • Sharpening rail 45° • Bending rail • Operation manual Dimensions: approx. L 3.55 x W 1.1 (plus yellow warning plates) x H 2.0 m

sheet width 3000 mm︱plate thickness 6,00 mm︱distance between columns mm︱opening of the upper cheek 450 mm︱opening of the down cheek 125 mm︱Opening of the bending cheek 125 mm︱total power requirement kW︱weight of the machine ca. 7,00 t︱dimensions of the machine ca. m︱

---

- Renewed control cabinet with Siemens control - controlled back gauge 1000 mm - Crowning adjustment - Support table with wheels - various bending rails including sharp rail - segmented goat's foot - Operation manual

sheet width 1050 mm︱plate thickness 8,00 mm︱distance between columns 1250 mm︱angle adjustable from - to 0 - 180 Grad︱upper clamping bar adjustment 350 mm︱traversing speed OW 4,4 mm/sek︱Control ELGO TYP 86 ︱back stop - adjustable max. 1000 mm︱engine output 5,5 kW︱weight of the machine ca. 3200 kg︱range L-W-H 1900 x 2600 x 1600 mm︱

---

** maintained condition ** with a lot of bending tools (!!) ** Pointed rails, radius rails, bending rails, divided goat's foot rails etc. Furnishing: - heavy duty heavy duty folding machine, easy to operate - Angle adjustment via electric potentiometer - ELGO NC control unit TYPE 86 for electric backgauge - NC electric backgauge, with rear sheet metal support surface - electric/motorized bending beam - Electric/motorized upper beam .. max. 350 mm - manual lower beam adjustment .. max. 125 mm - manual bending beam adjustment .. max. 125 mm - Upper beam with 2x guide spindles - 1x free moving foot control - 1x mobile tool cabinet for bending tools Manufacturer description: - electronic lifting height and bending angle adjustment - Deactivation of the upper beam lifting height and the clamping pressure via timing relay and voltage meter - Pushbuttons for controlling the upper and bending beam with manual switching, included Upper beam can also be operated via foot switch - Adjustability of all cheeks - Silent twin motors oil bath worm gear - Two-way drive of upper and bending beam via 2 continuous shafts - Drive of the upper beam via threaded spindles - Drive of the bending beam via internal toothed segments

sheet width 3100 mm︱plate thickness 3,00 mm︱distance between columns mm︱cutting angle 1-3 °︱no.of strokes 18 /min.︱total power requirement kW︱weight of the machine ca. 3,60 t︱dimensions of the machine ca. 3,70 x 2,00 x 1,55 m︱

---

Furnishing • Controlled backgauge 1000mm • SIMATIC OP7 controller • Finger protection • Angle stop 1000mm • Support arm • Manual cutting gap adjustment